9/8/2023 0 Comments Zebra scanner not scanning![]() ![]() Then tap the (i)-icon and tap "Forget This Device". Zebra Barcode Scanner Not Working Zebra barcode scanner wont read barcodes properly Zebra barcode scanner wont power on despite having a fully charged.Verify that the device can read the type of barcode being scanned (See Specifications ). maintaining, and troubleshooting the DS9908 scanner. Device is not programmed for the barcode. This manual contains proprietary information of Zebra Technologies Corporation and its subsidiaries. When it appears, tap it to connect to it. Move the device closer or further from the barcode to the proper scanning range.Wait for the scanner to appear in the list (if it doesn't show up, try scanning the codes above once again). ![]() If all of the above has been attempted but the scanner is still not showing up, try the following: A bluetooth dialogue should appear in Sitoo POS asking you to confirm the bluetooth pair.When your scanner appears in the search results, tap on the row.Check that your scanner is fully charged. Please repeat the previous step (7+8) a couple of times if you're not receiving a result right away. Troubleshoot Bluetooth Barcode Scanners Confirm youre using an iPad or iPhone with a Bluetooth scanner.Now an alternative for Zebra should appear in the list.Then tap the magnifying glass in the upper right corner.To select a beeper volume, scan either the Low Volume, Medium Volume, or High Volume barcode. Scan one of the following barcodes to suppress or not suppress linear imager scanner beeps upon power-up. Enter the number 2 in the IP-Address-field. To select a decode beep frequency (tone), scan one of the following barcodes: Suppress Power Up Beeps.Tap the plus icon in the upper right corner and choose Zebra.Swipe from right to left on the row Zebra > Remove.Under Hardware Devices you'll see a list of all currently connected devices.Open Sitoo POS > Menu > Settings > Hardware Devices.Scan the barcode below to Turn on pairing:.Scan the barcode below to reset the scanner:.On the iPad > Settings > scroll at the bottom of the app list to the left > Select Sitoo POS > Allow Bluetooth access. Make sure that Bluetooth access is allowed.On the iPad > Settings > Bluetooth > make sure Bluetooth is turned on.The cable should be connected to an electric adapter, no other device. Ensure that the base station receives power through a micro usb cable.The scanner consists of two parts a wireless hand scanner and a base station. It's connected to Sitoo POS via bluetooth and thus is not network dependent. Is anyone else also experiencing this problem? Attached is a small test application that has 4 different ways to start the scanner.The Zebra DS2278/CS60 barcode scanners are robust bluetooth scanners. When we look for the scanner that has a scannerType like "Camera" things seem to work just fine. The scanner state can be retrieved using Get Scanner Status or Register for. ![]() Suspend / Resume - much quicker but can be called only when the scanner is in the SCANNING or WAITING state. "Error setting barcode property: parameter is not recognised"Īfter some investigation, it seems to be the scanner with the type "Laser" (that is the default) that gives this problem. A: There are two methods to temporarily disable the barcode scanner in an app using the Scanner Input Plugin: Enable / Disable - can be called at any time. When we use the JS API to start the Barcode scanning with this code: And with that we are running into some issues with Barcode scanning. ![]() We are currently looking into getting our device ready to be deployed on the Motorola TC55. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |